Dynavector DV 20X2-H settings - Printable Version +- Devialet Chat (https://devialetchat.com) +-- Forum: Devialet Chat (https://devialetchat.com/Forum-Devialet-Chat) +--- Forum: The Vinyl Thread (https://devialetchat.com/Forum-The-Vinyl-Thread) +--- Thread: Dynavector DV 20X2-H settings (/Thread-Dynavector-DV-20X2-H-settings) |
Dynavector DV 20X2-H settings - Digitalhead - 21-Jun-2015 Hi everyone, I have a Dynavector 20X2H, high output MC cartridge (on a Michell Gyro SE with TechnoArm "A"), probably the only Dynavector model for which there is no preset in RAM. I'm using the same settings as a normal MM with 3,0mV as maximum input level. Any suggestions as to the other settings? Thanks! RE: Dynavector DV 20X2-H settings - kylevuong - 23-Oct-2018 Hi there, I have the same cartridge as you and now I'm stuck at setting up the Devialet, mine one is Devialet Expert 200. My turntable is Clearaudio Concept. Can you please share with me your setting that you think it works? I found the specs of the cartridge as below: Type : High output MC cartridge with Flux damper and Softened magnetism Output voltage : 2.8mV Frequency response : 20 - 20,000Hz (±2dB) Channel Separation : 25 dB (at 1KHz) Channel balance : 1.0 dB (at 1KHz) Compliance : 12 x 10-6 cm/dyne Impedance : R=150 ohms Stylus tip : Micro Ridge Nude diamond Cantilever : 6mm length hard aluminum pipe Tracking force : 1.8 - 2.2 grams Recommended load impedance: >1000 ohms Weight : 9.2grams |