To DPM or not? That is the question. - Printable Version +- Devialet Chat (https://devialetchat.com) +-- Forum: Devialet Chat (https://devialetchat.com/Forum-Devialet-Chat) +--- Forum: Devialet Expert 400/800, Original d'Atelier, Expert 210/440/1000 Pro (https://devialetchat.com/Forum-Devialet-Expert-400-800-Original-d-Atelier-Expert-210-440-1000-Pro) +--- Thread: To DPM or not? That is the question. (/Thread-To-DPM-or-not-That-is-the-question) |
RE: To DPM or not? That is the question. - Dan - 17-Nov-2017 My amps are in a cabinet that I built with lots of passive ventilation. I’ve never had a problem before. As I said earlier once the DPM was turned back on the temps were fine. I was going to try turning the DPM off, but, in discussions with Dev support they suggested if I was going to get the new Core board they would prioritize the update. So, for better or worse, I just delivered both amps to fedex...... Once I get them back I’ll try turning off the DPM and report back. RE: To DPM or not? That is the question. - ogs - 17-Nov-2017 I believe Devialet knows the problem with the cooling pad. Your amps will hopefully come back without any temperature problems! EDIT: I've just checked my 250. In 'light' stand by I have A:34 D:36 P:44. I'll read temps after playing some songs later this evening RE: To DPM or not? That is the question. - ogs - 17-Nov-2017 After playing medium loud around 45 minutes I have A:43 D:38 P:46. Only the class A amp has risen a little, 9 degrees. The D-amp and power supply only 2 degrees. RE: To DPM or not? That is the question. - f1eng - 18-Nov-2017 FWIW when I compared DPM on and off I heard no difference. My speakers are 109dB/watt if that makes much difference. RE: To DPM or not? That is the question. - Rufus McDufus - 18-Nov-2017 I have to admit with my D200 I couldn't tell a difference either. To DPM or not? That is the question. - Soniclife - 18-Nov-2017 I think it's speaker dependant, with my old speakers I could not hear a difference, but could with the new. RE: To DPM or not? That is the question. - Jean-Marie - 18-Nov-2017 (18-Nov-2017, 19:06)f1eng Wrote: FWIW when I compared DPM on and off I heard no difference. My speakers are 109dB/watt if that makes much difference. Mine are only 88dB and still I can’t hear any difference. Jean-Marie RE: To DPM or not? That is the question. - pisabell - 18-Nov-2017 Hello all, I cannot find the DPM setting in the config panel for my D400. Where is it supposed to be? Thaks a lot, Pierre RE: To DPM or not? That is the question. - Dan - 18-Nov-2017 @pisabell - it’s under general setting/power saving RE: To DPM or not? That is the question. - sven911 - 19-Nov-2017 Under my 1000 Pro units I created large cooling holes and the units stay quite cool. I can not read the temps because the units are in Paris for the upgrade. I also prefer DPM off. |