+- Devialet Chat (https://devialetchat.com)
+-- Forum: Devialet Chat (https://devialetchat.com/Forum-Devialet-Chat)
+--- Forum: Support Desk (https://devialetchat.com/Forum-Support-Desk)
+--- Thread: New Speakers -> Power up thump (/Thread-New-Speakers-Power-up-thump)
New Speakers -> Power up thump - rwjr44 - 19-Oct-2015
Hi Folks,
I installed my Legacy Audio Focus SEs yesterday, they replaced a set of Magnepan 1.8s. Now I hear a low frequency thump after the D200 completes is startup sequence. The thump may have been there before since the 1.8s didn't go much lower then 40Hz.
Anyone have this problem?
If so, your guidance will be appreciated.Thanks,
Bob
RE: New Speakers -> Power up thump - baddog - 20-Oct-2015
No thump here. D400 to Vivid G3s. This is either with or without SAM enabled.
RE: New Speakers -> Power up thump - AaronG - 20-Oct-2015
I have always had a thump with my GPs, SAM or not.
RE: New Speakers -> Power up thump - rwjr44 - 20-Oct-2015
Thank you.