Devialet Chat

Hi guys.

Here am I, with brand new D200 and B&W 805 D !!!!!

Just updated with 7.1.3 (the factory firmware was 7.1.2) and made a quick config.

I just begin with some difficulties, first the IOS remote on my iPhone just shows informations, but I can't interact, if I perform an actions notion happens, but if I use the real remote I can see the new information on the iPhone.....

Second, I just installed AIR on my windows PC, but I can't enable AIR streaming, I just see Disable Devialet AIR that is ticked on the icon in the task bar...

So I begin this journey with CDs !!!!!!

Advices will be appreciated

Edit (May 2016): pictures in my new apartment

Another sighting of the illusive 7.1.2 .....

I do not understand....
The wifi is set up, on the dev screen it's ok, ip showed... But I can't ping it....

Is the wifi faulty ?

When wifi only, on the remote app of the iPhone I see Wifi, but can't control anything, when I plug my Ethernet cable, then it show eth on the remote and I can control....

(22-May-2015, 18:59)ledesc Wrote: [ -> ]I do not understand....
The wifi is set up, on the dev screen it's ok, ip showed... But I can't ping it....

Is the wifi faulty ?

Sounds unlikely that the wi-fi is faulty if it's connected to the AP and been assigned an IP address (I assume you're using DHCP).

Firewall problem?  Are you pinging it from a PC or Mac? Oh, I see you mentioned "task bar" above so I guess a PC. Might be worth trying with the firewall disabled, temporarily.

Yes I both tried DHCP and fixed IP.
You can ping the wifi IP ?
I have no firewall, everything (iPhone, iPad, PC...) can connect to the internet box in wifi.

Yes, the wi-fi interface should respond to ping. (At least, it does with 7.1 firmware; I haven't tried 8.0.)

I meant the Windows firewall, by the way.

Have you tried a wired connection?

(22-May-2015, 17:44)ledesc Wrote: [ -> ]Hi guys.

Here am I, with brand new D200 and B&W 805 D !!!!!

Hello

Listen Your system with SAM on!!! 805D sounds much better with SAM...

Yes SAM on
I put another config (DPM off) and know the app remote works....
Will check tomorrow as my wife just arrived from work.
Let's demo with her favorite CDs !!!!!!

(22-May-2015, 17:44)ledesc Wrote: [ -> ]I just begin with some difficulties, first the IOS remote on my iPhone just shows informations, but I can't interact, if I perform an actions notion happens, but if I use the real remote I can see the new information on the iPhone.....

Did you under configurator, remote settings "Authorised" app remote control? If not, enable it and load new configuration into devialet.

Great stuff! Maybe DPM turns off the network interfaces when the unit is in standby - if so, thanks for finding out!

Anyway, enjoy your listening!