Just had my 400 delivered today. Sounds fantastic, however the streaming side is pants, as I sort of knew but didnt expect it to be unusable on Hi Res files.
My question...
I have the two units stacked, and they are VERY hot. like almost too hot to touch. You couldnt hold one for very long thats for sure!
Is this ok?
Thanks.
Hmm, none the wiser really. Is there a way to get a read-out of the temp within the settings?
hold the button on the bottom right for a few seconds and it will bring up a list of settings. keep clicking that button until you get to the temperature page.
hold the button down again to leave the menu
personally - i wouldnt stack my amps!!! i leave mine on 24/7 and even without playing any music they can be really hot to the touch.
(11-Nov-2015, 23:26)jukemark Wrote: [ -> ]Hmm, none the wiser really. Is there a way to get a read-out of the temp within the settings?
Long press on the right button on the remote, then scroll through the many screens of info, you will then find the temps. Anything over 65 deg, immediately panic!
Thanks guys!
Next question...
Is there a way to see the resolution of a stream coming into the amp (I am using it an Amp as the streamer is complete rubbish!)?
Thanks in advance.
Looks like me and mr luxury overlapped! Anyway, just thought I'd check my own temps out of interest, then found I have an error message. "Last fault P1 mains under voltage", I thought these things could run down to 110v, and I'm in the 240v UK? Nothing to worry about I guess as all sounds good. Anyone know what this might mean?
(11-Nov-2015, 23:46)jukemark Wrote: [ -> ]Thanks guys!
Next question...
Is there a way to see the resolution of a stream coming into the amp (I am using it an Amp as the streamer is complete rubbish!)?
Thanks in advance.
Long press the left button on the remote. This gives the bit rate (kHz) but not hit size, 16 bit or 24 bit etc, slightly annoying!