Today I noticed that the online configurator, when asking to upload the present config, doesn't show all settings as they are/should be on the config file according to my last settings session. Some settings are there, others are missing completely. Does anybody else have the same experience?
Firmware 8.1.3
(26-Nov-2015, 12:19)Mohmm Wrote: [ -> ]Today I noticed that the online configurator, when asking to upload the present config, doesn't show all settings as they are/should be on the config file according to my last settings session. Some settings are there, others are missing completely. Does anybody else have the same experience?
Firmware 8.1.3
Yes, I found that the confugurator never remembers that mute should only apply to the loudspeakers; it assumes each time that mute also applies to the analogue output. For me, this is the only bug I encountered.
Yes mine does that too. I have to do the mute button and the input start configuration every time.
Whenever I run the configurator on an existing config, at least as far back as I can remember, the default input always goes back to 'last selected' rather than USB I have saved. I have to manually put that back.
Yes. I've also had problems with the preamp (sub-woofer) output configuration being "forgotten" between visits to the configurator. That may be unique to dual-mono, I'm not sure. Devialet have confirmed that it is a problem but -- as is becoming traditional -- haven't given any indication of when it will be fixed.
I second the default input choice being accidentally overridden (happens on my D120)... although I thought it was going back to the *first* named Input, and only after I changed any of the other General Settings.
I logged a ticket about the input issue a while back and I received a message a week or so ago that they're actually working on it.
Fine, so I am not alone. In my case Le Conf. does not recognize the inputs that I had deactivated plus some other settings.
(27-Nov-2015, 19:49)Mohmm Wrote: [ -> ]Fine, so I am not alone. In my case Le Conf. does not recognize the inputs that I had deactivated plus some other settings.
Today it worked well again and read all settings on my file correctly. Seems to have been a temporary glitch.