Hi ,
can anyone clarify how can i lock phantom to generic stands ?
i have my eye on the soundstyle z2 a cheap award stands.
https://www.whathifi.com/soundstyle/z2/review
the stands plate is 16.6cm on 12.5cm so i think its good enough for the phantoms.
my problem here is how to secure it to the plate (little kids,dog etc...
)
if it involved some more holes i can do it manually but there a grey plastic underneath the phantom and i can figure out if its detectable/screwble or whatever.
please advise...
Elad
(19-Jan-2020, 17:07)eladeb Wrote: [ -> ]Hi ,
can anyone clarify how can i lock phantom to generic stands ?
i have my eye on the soundstyle z2 a cheap award stands.
https://www.whathifi.com/soundstyle/z2/review
the stands plate is 16.6cm on 12.5cm so i think its good enough for the phantoms.
my problem here is how to secure it to the plate (little kids,dog etc... )
if it involved some more holes i can do it manually but there a grey plastic underneath the phantom and i can figure out if its detectable/screwble or whatever.
please advise...
Elad
It's a non detachable pin. You can make a bracket for securing the speaker. See attached drawing and picture of the original Devialet mounting solution.
(19-Jan-2020, 17:07)eladeb Wrote: [ -> ]Hi ,
can anyone clarify how can i lock phantom to generic stands ?
i have my eye on the soundstyle z2 a cheap award stands.
https://www.whathifi.com/soundstyle/z2/review
the stands plate is 16.6cm on 12.5cm so i think its good enough for the phantoms.
my problem here is how to secure it to the plate (little kids,dog etc... )
if it involved some more holes i can do it manually but there a grey plastic underneath the phantom and i can figure out if its detectable/screwble or whatever.
please advise...
Elad
I don't have Phantoms, but if you look at Gecko there is a small handle where a hook on the Phantom bottom (hidden under the rubber) slides in and holds the speaker. A bit of DIY is required on your part as the the stands are not original Devialet.
[
attachment=3825]
Ah, @
ragwo beat me to it!
@
ragwo @
ogs
Guys thanks a lot!
Btw the drawin in pic no 2 is mm?
Made my own plate.
Il send some sketches i i did later one.
(Can't attech via android to the the thread)