07-Aug-2021, 10:36
07-Aug-2021, 10:36
07-Aug-2021, 14:56
Not quite sure what you are asking but as your picture is of the configurator I assume you are referring to that.
In the configurator you need to click on a connector to enable the non default connections.
Those with an orange selector can be configured.
Those that can't are grey.
Clicking on a connector will toggle between orange and grey and the connector will be highlighted.
You must already have done this to get the trigger connection.
In the configurator you need to click on a connector to enable the non default connections.
Those with an orange selector can be configured.
Those that can't are grey.
Clicking on a connector will toggle between orange and grey and the connector will be highlighted.
You must already have done this to get the trigger connection.
08-Aug-2021, 21:33
Controll RS232 cable, lover ( master ) and uper ( companion ) and good connection, or try change cable