(24-Feb-2018, 09:56)Fragoulisnaval Wrote:

(23-Feb-2018, 23:04)MIO2013 Wrote:

(23-Feb-2018, 11:35)Fragoulisnaval Wrote: @Axel

This is the emi/rfi absorbing sheet from Stillpoints, a gift from my dealer for purchasing the complete set of ultra SS.

I want to pyrchase anotherbone to put it on the top of D, for better shielding.

I do not expect to hear any differences, purely psychological reasons for this purchase....

Στάλθηκε από το ALE-L21 μου χρησιμοποιώντας Tapatalk

Wow, that is quite an elaborate set up you have there. I figured that the amp itself was just too light to make a difference. 

As I wrote, I have some BDR cones and disc's that do a pretty good job with SQ, and great for temp. 

I am going to do some switching back and forth this weekend and make a determination.

Thanks for that input!!

I have

D is too light in my opinion for the ultra SS to work, that is why ibout the three weights on top in order for them to work better.

My plan is to tepace them with something heavier,if possible and with some dampening material, something like the HR stuff I read a review one month ago....

Experimenting is the way to go as far as vibration control is concerned, D could be very well affected depending on the material and way of support. Not much, but smalll differences are there

Have fun and share your experience with us

Cheers!

Στάλθηκε από το ALE-L21 μου χρησιμοποιώντας Tapatalk

(26-Feb-2018, 16:07)MIO2013 Wrote:

(24-Feb-2018, 09:56)Fragoulisnaval Wrote:

(23-Feb-2018, 23:04)MIO2013 Wrote: Wow, that is quite an elaborate set up you have there. I figured that the amp itself was just too light to make a difference. 

As I wrote, I have some BDR cones and disc's that do a pretty good job with SQ, and great for temp. 

I am going to do some switching back and forth this weekend and make a determination.

Thanks for that input!!

I have

D is too light in my opinion for the ultra SS to work, that is why ibout the three weights on top in order for them to work better.

My plan is to tepace them with something heavier,if possible and with some dampening material, something like the HR stuff I read a review one month ago....

Experimenting is the way to go as far as vibration control is concerned, D could be very well affected depending on the material and way of support. Not much, but smalll differences are there

Have fun and share your experience with us

Cheers!

Στάλθηκε από το ALE-L21 μου χρησιμοποιώντας Tapatalk

Well, I took a cue from you Fragoulisnaval ...

After moving around the stillpoints and not getting much of a difference, I added some weight like you did. One on each side but not the front or back. BAM!! I could hear it before I even got back to my sweet spot. The soundstage and voice clarity just popped! Way outside the speakers and way behind the back wall. I was just about to send these back because they are on loan, but I think I will be hanging on to them. Made that much of a difference. 

I also tried your config with the weights, but it flattened out when I put the one in the back like yours. I also tried at all four corners, but got the same thing. Took those out and went back to one in the middle of each side....BAM!

Like you said, experimenting is part of the fun! Thanks for the pics and the suggestion!

(28-Feb-2018, 10:28)imprezap2 Wrote: Ansuz darkz ceramic footers (3 total)worked miracles under my Devialet D200