Cartridges and phono settings - Printable Version +- Devialet Chat (https://devialetchat.com) +-- Forum: Devialet Chat (https://devialetchat.com/Forum-Devialet-Chat) +--- Forum: The Vinyl Thread (https://devialetchat.com/Forum-The-Vinyl-Thread) +--- Thread: Cartridges and phono settings (/Thread-Cartridges-and-phono-settings) |
Cartridges and phono settings - no32 - 18-Apr-2020 I’ll try and let you know Thx Sent from my iPhone using Tapatalk RE: Cartridges and phono settings - Rhapsody - 22-May-2021 Hi, I read through all 20 pages of this thread, but could not find my exact situation and question. If someone can verify the max load ballpark setting for a Ortofon MC SPU G MK II Classic cartridge with an Output voltage at 1000 Hz, 5cm/sec. - 0.2 mV. From reading the posts I would guess at 200 uVRms, maybe 210-220 uVRms. To start the setting was at 450 uV rms and the volume has to be turned to 0 to + 10 to listen. I would have thought you would raise the uV setting but after reading I believe it's the opposite. If someone is certain about this, please confirm. Thank you in advance. It is appreciated! RE: Cartridges and phono settings - Rhapsody - 25-May-2021 (22-May-2021, 11:44)Rhapsody Wrote: Hi, I read through all 20 pages of this thread, but could not find my exact situation and question. If someone can verify the max load ballpark setting for a Ortofon MC SPU G MK II Classic cartridge with an Output voltage at 1000 Hz, 5cm/sec. - 0.2 mV. I will answer my own question as maybe it will help someone in the future. With a MC that has a .2mv output the setting on the max output should be around 210uV. If it is set much higher the gain is reduced. Max setting lower, higher gain. Max setting higher, lower gain. Cheers. RE: Cartridges and phono settings - jorgie - 26-May-2021 Hi, I run my SPU Classic GM E MkII with these settings: Max. Level = 200µVRMS Loading = 22Ohms / 0pF - 14Ohms should also be feasable Sounds very convincing in my setup Best regards RE: Cartridges and phono settings - Rhapsody - 26-May-2021 Thx, confirms how I ended up with the installation. Appreciate it. RE: Cartridges and phono settings - Bartype - 27-May-2021 What is the best startup curve to be used, when to use which one? RE: Cartridges and phono settings - Rhapsody - 27-May-2021 (27-May-2021, 12:13)Bartype Wrote: What is the best startup curve to be used, when to use which one? Good question. No idea RE: Cartridges and phono settings - TanteTruus - 24-Nov-2021 Hi all, I picked up a Rega RP6 TT fitted with a Ania MC cartridge. Could someone tell me the correct settings for this in my Devialet amp please? Thanks in advance for the replies. Tante Truus RE: Cartridges and phono settings - Jens - 24-Nov-2021 Hi TT, Try these settings: Sensitivity 0.50 mv Loading 100 ohm + high pF Best regards, Jens RE: Cartridges and phono settings - TanteTruus - 25-Nov-2021 (24-Nov-2021, 17:45)Jens Wrote: Hi TT, Hi Jens, Many thanks for your reply. I will try those settings. Tante Truus |