D400 as a pre amp - Printable Version +- Devialet Chat (https://devialetchat.com) +-- Forum: Devialet Chat (https://devialetchat.com/Forum-Devialet-Chat) +--- Forum: Devialet Expert 400/800, Original d'Atelier, Expert 210/440/1000 Pro (https://devialetchat.com/Forum-Devialet-Expert-400-800-Original-d-Atelier-Expert-210-440-1000-Pro) +--- Thread: D400 as a pre amp (/Thread-D400-as-a-pre-amp) |
D400 as a pre amp - dylanttt - 13-Jan-2019 I have had a D400 for 6 years and just brought 2 pairs of Vincent SP-T800's.Using the Dev for the Bass and 1 pair of Vincents for mids and 1 pair for highs. The sound improvement is huge.Bass is better as well.Is any one else using there Dev in a similar way?? RE: D400 as a pre amp - BrianT - 13-Jan-2019 In Sept 2018 at Carverfest, I built 2 Carver Crimson 275 tube amps, since then I have been using my Dev 220PRO as a preamp only driving a single Crimson 275. I I could use 2 separate Preamp outs on the Dev, I would run the 2 Crimson tube amps in stereo mode, one would be for the mids and highs and the other for the Bass. I am interested on how you have the output from your Dev 200 wired. Brian RE: D400 as a pre amp - dylanttt - 13-Jan-2019 I have a 400. i have a Y splitter from the mono out, to 2 amps, from 1 200(left channel). and the same for right channel. 4 Mono blocks in total. plus the 2 Dev 200s (400) And they are all running full range. I am using the D400 to drive bass to utilise the SAM. Speakers are VAF Research(Australian made) RE: D400 as a pre amp - dylanttt - 13-Jan-2019 You can configure your 200 to have stereo pre outs RE: D400 as a pre amp - BrianT - 14-Jan-2019 (13-Jan-2019, 23:09)dylanttt Wrote: You can configure your 200 to have stereo pre outs I looked and could not figure that out, can you please give me some hints. Brian RE: D400 as a pre amp - Pim - 14-Jan-2019 (14-Jan-2019, 00:59)BrianT Wrote:(13-Jan-2019, 23:09)dylanttt Wrote: You can configure your 200 to have stereo pre outs RE: D400 as a pre amp - Pim - 14-Jan-2019 It's on these pre-outs. When you change fro digital, it comes up at stereo pre-outs right away. RE: D400 as a pre amp - BrianT - 14-Jan-2019 (14-Jan-2019, 04:18)Pim Wrote: It's on these pre-outs. When you change fro digital, it comes up at stereo pre-outs right away. Pim I am using the outputs that you mentioned, feeding the full bandwidth stereo signal to one tube amp. (no speakers output on the Dev) What I would love to do is have a second pre out, using one of the other input's, that way I would feed the high stereo signal to one amp and the low stereo signal to the other and then run 2 pairs of speaker cables using 1 amp to feed both speaker highs and 1 amp to feed both speaker lows. Brian |