using input 1 on companion - Printable Version +- Devialet Chat (https://devialetchat.com) +-- Forum: Devialet Chat (https://devialetchat.com/Forum-Devialet-Chat) +--- Forum: Support Desk (https://devialetchat.com/Forum-Support-Desk) +--- Thread: using input 1 on companion (/Thread-using-input-1-on-companion) |
using input 1 on companion - dylanttt - 24-Mar-2015 i am having trouble getting any sound using input 1 on the slave unit,has anyone got any suggestions RE: using input 1 on companion - Mikeeo - 24-Mar-2015 (24-Mar-2015, 05:16)dylanttt Wrote: i am having trouble getting any sound using input 1 on the slave unit,has anyone got any suggestions Hi and welcome to the forum! Well, take a close look at your configuration as you perhaps missed to enable that function. Talking about input 1 I guess you mean Dig 1, or? Do both units play? Do you use AES/EBU input then I am not sure you could use input 1. Input 1 is the one to hook up the companion with the master if not using AES/EBU. But with regards to the hidden configurator glitches specially for mono set up my comments above may be useless. /Mike RE: using input 1 on companion - Gavin @ Guildford Audio - 24-Mar-2015 Hi, I assume that you have a 3.5mm cable running between the two Dev's? If not, this could be your problem. Regards Gavin RE: using input 1 on companion - Mikeeo - 24-Mar-2015 (24-Mar-2015, 16:49)Gavin @ Guildford Audio Wrote: Hi, Correct this one is a must if you want to use the companion inputs. I don't any longer as master covers my need. I also run the AES/EBU input on the companion so I can't use any in/output except subwoofer out, I think. /Mike RE: using input 1 on companion - dylanttt - 24-Mar-2015 thanks for the replies,I have a 3.5 cable running between the 2,and using digital 1 on both units to connect the master to the slave.But would like to use the line 1 on the slave unit if that is possible.as i am using line 1 and 2 on the master |