Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to attach the Branch
#9
(31-Jan-2016, 17:13)ERP Wrote: A last desperate attempt succeeded, since the optical cable didn't slide out when connecting the power cable. The Phantom is connected and "locked", although it can still move around a little bit. Is this normal?

I asked this question in the main Branch thread but didn't get a reply. From my experience, the front of the phantom latches to the Branch, but the back can be lifted up and away from the stand if you try lifting the back end of the Phantom. It seems the latch/lock mechanism has quite a bit of slack in it as its only held at one point, and the back-end of the phantom just rests on the stand. I queried this in the other thread because I was trying to figure out what the safest / correct way of moving the Phantom on a Branch is. It seems dangerous/wrong to lift the Phantom with the stand dangling. But there is no easy way to grip the structure to move it once assembled as it does NOT slide on carpet and does need to be lifted "somehow".
Reply


Messages In This Thread
How to attach the Branch - by ERP - 31-Jan-2016, 14:54
RE: How to attach the Branch - by ragwo - 31-Jan-2016, 15:07
RE: How to attach the Branch - by f1eng - 31-Jan-2016, 15:56
RE: How to attach the Branch - by ERP - 31-Jan-2016, 16:33
RE: How to attach the Branch - by ERP - 31-Jan-2016, 17:13
RE: How to attach the Branch - by jonstatt - 31-Jan-2016, 20:11
RE: How to attach the Branch - by ERP - 31-Jan-2016, 20:53
RE: How to attach the Branch - by f1eng - 31-Jan-2016, 17:20
RE: How to attach the Branch - by Bogardo - 31-Jan-2016, 18:06
RE: How to attach the Branch - by ERP - 31-Jan-2016, 20:47
RE: How to attach the Branch - by ERP - 31-Jan-2016, 18:17
RE: How to attach the Branch - by ERP - 31-Jan-2016, 22:01
RE: How to attach the Branch - by Bogardo - 31-Jan-2016, 23:16

Forum Jump:


Users browsing this thread: 1 Guest(s)