Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Headphones - filter settings for vinyl?
#4
(22-Oct-2016, 18:44)Peter van der Laarse Wrote:
(01-Oct-2016, 18:27)DelaneyB Wrote: Hi
Had forgotten how much headphones exacerbate the surface noise....

Since the Devialet allows filter settings on the line out, any suggestions as to where to start?

I'm using a Graham Slee Solo ultra Linear with Grado SR325s..

Tx

Surface noise? Your turntable is not in order. Possible:
1. Which cleaning machine are you using? Clearaudio? Okki Nokki? You MUST remove the press residu from the LP you naturally know.
2. How is the set earthed? Look at all the Power cable products from Kemp Elektronics and you learn a lot. Is the ground earth < 0,1 ohms? Pins on the corners of
the house more then 10 meters into the ground? Earth only sound? radio? TV?
3. Is the height of the arm set right? Try different settings
4. The element is connected with the Devialet in a balanced way? Try
5. Headphones don't exacerbate: bigger moving coil speakers can't follow the details in the sound..... Stax vs ESL no difference at all
6. Element tested and needle in order?

New Rega P3/Exact - I am playing some 40+ yr old vinyl... cleaned with vinyl rejuvenator gel. So I'll expect to hear more pops and crackles with headphones I suppose. Sounds superb otherwise.
Devialet 250 FW 9.0.1 SOLD
Replaced with Naim NSC222 and NAP250 NC

Atohm GT SE1, REL stereo Subwoofers. Atacama stands filled with atabites. Granite speaker stand plinths. Mogami speaker cables, Music Works heavy duty power cable.
Quadraspire 'toilet seat' acrylic rack
Sources:
1. Mac Mini 2021 M1
- Qobuz/Audirvana Studio/ Audirvana app on iPad (Via Mac mini)
2. Vertere DG-1 with Magneto upgraded to fine line stylus

Reply


Messages In This Thread
RE: Headphones - filter settings for vinyl? - by DelaneyB - 24-Oct-2016, 22:28

Forum Jump:


Users browsing this thread: 1 Guest(s)