Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to connect forks to the Dev's speaker outputs?
#11
I had the same problem and here is how i did manage before moving to banana.

That plastic housing on the base is not glued. So with very little force they come loose. Just turn them up 180 degrees, fit hem back and you have the larger opening towards the top. Then any size spade should fit easily.

If you do not place them back nicely, you will have connection problems, so just a little patience.

Cheers
Kii Three, dCS Network Bridge, Roon Nucleus, Kuzma (Stabi S, 4Point), Soundsmith StrainGauge, Stromtank, Echole Cables 
Istanbul, Turkey
Reply
#12
Thanks All for your kind input!

Kunter I'll try your suggestion. As I am running my units side by side I will have no problem with unit-unit interference.

/Mike
Ex D400 Now Aavik U-300/Feickert Woodpecker2-Kuzma 4P-Kondo silver-Benz LPS-Teddy Pardo PSU/Naim Unitiserve-Teddy Pardo PSU/SF Guarneri Homage/Whole system decoupled by Ansuz DTC/Cables from Ansuz, DYI and other commercial/Dedicated mains and spur-Lampizator SILK
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)