D400 blinking db light (orange)

[Matix]

Hi All

Is this normal ?  Only have this örange blinking light when playing phono and when complicated orchestral passages with low frequencies comes in.  Same track playing from Lumin out has no such blinking light.

[Elztalbiker]

What cardrige do you use? 1st reduce load. That would be helpful.


Gesendet von iPad mit Tapatalk

[Matix]

What cardrige do you use? 1st reduce load. That would be helpful.


Gesendet von iPad mit Tapatalk

It is a Koetsu Rosewood.

[Matix]

Should I stop playing?  Worry damage to the Devialet 400

[Elztalbiker]

Load resistence between 80 Ohm and 1 kOhm. Try first middle 460. Next capacity between 150 pf and 300 pf. Hey also at first middle like 200 pf.


Gesendet von iPad mit Tapatalk

[Elztalbiker]

Don‘t forget to off Auto wifi an sampling rate to only 96 kHz


Gesendet von iPad mit Tapatalk

[Elztalbiker]

The settings above must work with your Koetsu rosewood, between the loads you could try, what‘s your sound preference.

Good luck


Gesendet von iPad mit Tapatalk

[Matix]

The settings above must work with your Koetsu rosewood, between the loads you could try, what‘s your sound preference.

Good luck


Gesendet von iPad mit Tapatalk

Thank you so much for detailed explanation.  I am playing through the 47 lab phonocube and not using the Devialet internal phono input.  However,  you did give me an idea to connect direct to the Devialet to find out if I still have the blinking issue. 
Turn out that direct input to the Devialet phono does not have problems.  Hence,  I have to conclude that the 47 lab phonocube is faulty.  Time to hunt for a phono stage, I guess...

[Elztalbiker]

Hello Matix, than it could be the Input voltage. What‘s your setting?

Input level you could turn um and down. Try it with low volume.

Best regards


Gesendet von iPad mit Tapatalk

[Matix]

Just checked. It is factory default. Same levels as what you just posted. Will try to to bring it down to see any improvements. Thanks!