Phantom elevate set up problem

[Marcner]

Hi all
What seems to be working best is when I have the dialog and 2x phantoms plugged into the same power strip. They go to PLC and seem to limit the drop outs. Can’t configure my room set up very easily however!

I have now tried WiFi, Ethernet and PLC and the PLC for me is the most stable.

What seems really odd is you can’t select what source function you wish to use? It just decides for you. So it could split between plc or WiFi depending on where I plug it in. This seems to cause messaging issues between my phantoms unless I plug them all together.

Have I missed something?
Thanks


Sent from my iPhone using Tapatalk

My experience was the same. Phantoms now work (almost) flawlessly. I used the Acoustic Research FS812 Flat Series Power Cord available on Amazon and recommended elsewhere on this site. The 12 foot length allowed me to place the Phantoms were I wanted them and still have them both plugged into the same power strip.