Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IP Control V1 2.14 interface notes
#8
(25-Feb-2022, 08:05)scotthar Wrote:
(24-Feb-2022, 13:43)s3kelman Wrote: re  Note: Exiting OFF mode is only possible by pressing a physical button on the device.

That caught my attention also.  so of course had to test it out. Smile

Discovered a workaround sort of, if you turn them off,  then cycle the main power (as in switch it off and on) they come back on.
without pushing the button.

I have been struggling to find a way to put them in standby as I don't have access to the button, maybe I will do an automation like: "put in standby, wait 2 minutes, cut power" to make things a bit more "clean" than just powering off these (I have a bunch of homekit plugs) but it bothers me a lot that there is no auto-standby / wake on these things, I mean it's 2022, how is that still possible, moreover for a product that expensive
Reply


Messages In This Thread
RE: IP Control V1 2.14 interface notes - by s3kelman - 25-Feb-2022, 11:12

Forum Jump:


Users browsing this thread: 1 Guest(s)