Companion Info Display not synching with Master

[amabrok]

When holding down Tone on the remote and pulling up the info display (temperatures, configs, SW version, levels, etc.), the companion and master display are no longer in synch (off by one page). It was in synch earlier but I updated my firmware on the master today....even with my SW version already being at 7.1.1 (reason being I couldn't get SAM level % to display). Good news is that the firmware update worked and it did resolve the SAM level % showing up but now the problem is that the master and companion are no longer in synch when displaying info. I've tried rebooting by holding power button down and also unplugging power on both units but still no resolution. Tried reloading both SD cards with the same config and still nothing. Makes no sense since the only difference from when it synched properly was the firmware update and there was no changes to my config.

Any suggestions?

I have the same. This is one of the of the reported bugs of dual mono configuration


Sent from my iPhone using Tapatalk