09-May-2015, 20:13
(08-May-2015, 23:05)kjj11 Wrote:(08-May-2015, 22:44)amabrok Wrote: Disconnect the master slave link and take out the SD card from ur slave unit a d reboot. This should boot up the slave unit in the factory default setup of D200. If this works then at least u know that the unit works and that the problem is with dual mono configuration
Sent from my iPhone using Tapatalk
All units indicates all as normal
But now I change my config and test standalone Devialet 200 configuration
And Ethernet port on it is silent! But if I back to 400 config - Ethernet works, but Phono didnt works
This is very strange
Maybe some power instability on home power line has dameged my Devialets?
Ethernet input may need some network settings to work, hence a (non factory) configuration.
Unless you also tried high resolution streams on the digital inputs, your issue, apparently only occurring on the analog inputs, seems to suggest that 192 kHz fails to transit between the master and the slave units: you may want to try another chaining cable, or to lower the sampling rate of the analog inputs from 192 to 96 kHz with the configurator. Hope it helps.
