Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Room Correction SW with JRiver
#8
sure. i wont have a silent room to test the software until the weekend unfortunately but just from having a quick look around the audio in - out is quite simple.

Acourate has its own ASIO driver. so when i load bughead SQ for example and it lists the different asio outputs it gives me 2: Jplay and Acourate.

so bughead will send the audio to acourate which does the convolving. then in acourate it asks for the audio output and gives me a list of all the possible options (for me its only Jplay)

it would be exactly the same with J-river. you can select the asio output in the settings and the acourate asio will be there. if you dont use jplay i assume you have a single pc. it would likely give you 2 output options. Devialet air and Devialet USB.

Far as i can tell you wont be able to swap on the fly between usb and air if you use the jriver remote.. but how often do you actually change between them?
Amp - Devialet 400 Speakers - vivid audio B1 Speaker cable - audioquest oak Power conditioner - furman SPR 16IE Source - audio PC with paul pang audio usb card v3 and paul pang red dual usb cable running through jplay. usb card powered by teddy pardo power supply Source 2 - line in from integra AV receiver (TV)
Reply


Messages In This Thread
Room Correction SW with JRiver - by baconbrain - 14-Jun-2015, 20:27
RE: Room Correction SW with JRiver - by Borgen - 14-Jun-2015, 20:43
RE: Room Correction SW with JRiver - by completeluxury - 15-Jun-2015, 14:52
RE: Room Correction SW with JRiver - by ogs - 16-Jun-2015, 16:25

Forum Jump:


Users browsing this thread: 1 Guest(s)