10-Aug-2016, 01:32
(09-Aug-2016, 17:18)Les Anderson Wrote: Sounds good to me. I would mind not to attenaute the digital signal with the TacT and control volume via the Devialet.
I also believe I have read somewhere that if you send the corrections needed to Devialet, they will build you a correction curve that you can load onto your Devialet. This may allow for you to remove the TacT from the signal chain after your room has been measured.
I think this is no longer possible. Longer term Dev owners will surely chip in on this, but basically Devialet used to offer this service but doesn't anymore. Probably because it diatracted their engineers from AIR solving chores...
L
Sent from my iPhone using Tapatalk
MBPro 2008 > Dev 120 > KEF LS50. Location: Buenos Aires, Argentina.
