Firmware 7.1.3 vs 8.1.3 vs 10.0.2

[no32]

So far I prefer it in every aspect. I find words are easier to understand , bass it tighter and deeper. I don't need to increase the volume anymore

I'm writing as I listen and It's harder for me to stop focusing on the music but it's so subjective

I didn't listen to large orchestra or my turntable yet but I'll get there sooner than later.

Btw what part of the FW effect the sound ?
Is it one specific file ? Is it to do with the power management ? Any thoughts ?

One problem though ,  amp started to shut down for splits of seconds. So far it happens several times

Any suggestions ?

Hold down the tone button on the remote for a couple of seconds, then press the source button a couple of times until you get to the screen which says "Last Fault", there you will see, yes, you've guessed it: the last fault detected. If you have a fault, raise a ticket with Devialet and please post the error code. You don't say what model you have.  Obviously, if you have a dual mono version (200, 220,400,440 etc.) don't forget to look at the data from both of the amps.

I was thinking that it might be useful for members if we had some sort of data base for error codes, although these sort of errors don't crop up in many posts. What do you think?

I searched for error and last fault is empty

I'm using 2 x 250 as 800
After resetting both amps I listen for about 4 hours without any issues at all.