28-Dec-2016, 14:30
(28-Dec-2016, 12:58)f1eng Wrote:(28-Dec-2016, 02:48)Duomike Wrote: It's important that the signal from all drivers arrive at your ear arrive at the same time! This got nothing to do with the phase of the recordings!
Why?
What, other than phase through the crossover, is effected by time alignment of the drivers?
In the Goldmund the tweeter and bass unit of the main speaker are offset by the difference at the speed of sound in air at the crossover frequency.
This is probably sensiblish, but since the 2 units share output over a reasonable frequency range it would be "wrong" for most of the overlap (if it mattered).
The main unit is adjustable on the bass box by a huge amount but probably pointless since at the crossover frequency the wavelength is huge, and adjustment could only have a negligible effect.
You are basically saying that the designer of your speaker and other designer like David Wilson are stupid making the effort to make their speakers adjustable in the time time domain. It's not these designers who are stupid!!
I have absolutely nothing further to say to you!
Highly modded avantgarde omega duos, slightly modded d200, d-sonics m3 800 s class d amp to drive the subs of my duos, all equipment on silent running audio platforms.
DCS Network bridge connected with AQ diamond to Router and with special Belden 1694a digital cable (cable is cryoed, mechanical damped and using very high quality solder to KLEI Harmony Bullet plug)
S/C is Shunyata biwire Delta, 2 Delta p/c on the bridge and bass amp, Synergestic dev p/c on the 200, all connected to Shunyata Denali power conditioner
DCS Network bridge connected with AQ diamond to Router and with special Belden 1694a digital cable (cable is cryoed, mechanical damped and using very high quality solder to KLEI Harmony Bullet plug)
S/C is Shunyata biwire Delta, 2 Delta p/c on the bridge and bass amp, Synergestic dev p/c on the 200, all connected to Shunyata Denali power conditioner
