01-Feb-2017, 16:06
Apologies for the delay with this, I only just got the chance to do some testing.
The 1000 Pro slave does have an RJ45 port, but although the link light comes on if you connect a LAN cable, it does not do anything.
Next, I took the SD card out and did a reset on both the master and the slave. Once reset, the display reverted to D250 Pro instead of D1000 Pro.
I managed to pair a remote with the 'slave' (which was now running as a single D250 Pro).
Phono input works
Still no Ethernet or Wifi though. Upon entering the diagnostic menu, it says both Wifi and Ethernet / Duet not installed on the slave - I always thought the RJ45 socket was part of the Duet board so I'm not sure what the 1000 slave has inside, but I wasn't about to open it up sorry!
The 1000 Pro slave does have an RJ45 port, but although the link light comes on if you connect a LAN cable, it does not do anything.
Next, I took the SD card out and did a reset on both the master and the slave. Once reset, the display reverted to D250 Pro instead of D1000 Pro.
I managed to pair a remote with the 'slave' (which was now running as a single D250 Pro).
Phono input works
Still no Ethernet or Wifi though. Upon entering the diagnostic menu, it says both Wifi and Ethernet / Duet not installed on the slave - I always thought the RJ45 socket was part of the Duet board so I'm not sure what the 1000 slave has inside, but I wasn't about to open it up sorry!