Hi Everyone,
Here are the instructions from Devialet to activate Optical Direct Mode in DOS2. One crucial step is to make sure the Premiers are attached to your network via ethernet and that they obtain an ip address.
Activation:
Here are the instructions from Devialet to activate Optical Direct Mode in DOS2. One crucial step is to make sure the Premiers are attached to your network via ethernet and that they obtain an ip address.
Activation:
- Option 1 : through the webpage
- Once connected on the network via RJ45, while in Setup mode (i.e. 15 minutes after RTF or after a reboot if the product is not configured via Blaze) ⇒ Click on an activation button in the “Wizard” page
- Sound design at activation
- An “Optical Direct” section appears for advanced settings (“Configuration”, “AirPlay PIN” & “Wi-Fi” sections disappear) :
- Mono mix (default) Left / Right
- Volume (see below)
- Mono mix (default) Left / Right
- If the 15 minutes period is over, one can either force the setup mode (3 single press on the back button) or reboot the speaker to enable the setup mode again.
- Once connected on the network via RJ45, while in Setup mode (i.e. 15 minutes after RTF or after a reboot if the product is not configured via Blaze) ⇒ Click on an activation button in the “Wizard” page
- Option 2 : 5 short press on the button during set-up mode only
- Sound design when it enters in Optical Direct (same sound design as BT connection)
- No LED on Phantom ⇒ sound design needed to understand it worked properly
- Sound design when it enters in Optical Direct (same sound design as BT connection)
- Back buttons actions deactivated in Optical Direct:
- 1 single = Status
- 3 single = Re set-up
- 1 single = Status
- Back button UX activated in Optical Direct:
- factory reset (very long press 7 sec)
- switch to standby (long press 2 sec)
- wake up from standby (1 single press)
- factory reset (very long press 7 sec)
- Option 1 : through the webpage
- Deactivation :
- From the webpage : in “General settings” ⇒ Reset to factory ⇒ No Reset to factory sound design (as today)
- On the product : very long press (7 seconds) ⇒ Reset to factory
- From the webpage : in “General settings” ⇒ Reset to factory ⇒ No Reset to factory sound design (as today)
6 x Phantom Gold, 3 x Phantom Silver, 2 x Phantom Classic, 9 x Phantom Reactor 900, Symetrix Radius AEC-2, 2 x JBL Synthesis SDP-55, Dante