Red protection light on 200! Suggestions?

[ZincAlloy]

now, and Ken - were there any warning symptoms before the failure?  From what I read above, it sounds as though it occurred while the units were in standby or switched off.

I ask because one of my 200s is emitting a slight but noticeable smell of burning epoxy resin (the "oops, that IC just exploded" smell...).  It seems to be working fine at the moment but I must say I'm a bit worried about it.

Hi thumb5 - no, nothing untoward noticed in advance.   I had the unit powered off completely because I was away for a few days.  It wouldn't turn on - screen remained blank.  To be honest, it's the first device that's ever failed on me, so I'm actually quite relaxed about it.  Stastically, I've done pretty well! Will give me a good excuse to hide from wife and rediscover headphone listening from iPad.  Not as bad as you may think.  

ATB, Ken