Red protection light on 200! Suggestions?

[Confused]

amabrok, I haven't seen anything like that behaviour on my 400, by the way.  I doubt it's to do with the power conditioner, unless it's providing a way out-of-spec mains input to your 400.

Thanks  thumb5. I agree, I don't think it is related to the power conditioner especially now that the sane issue appeared with isotek as well.

Why not try plugging it in to the mains directly?  If the fault persists it at least eliminates the Isotek as a possible cause.

Thanks Confused,

I will give it a go though I highly doubt Isotek is the problem here. But you are right, I will do it to element it and be sure


Sent from my iPhone using Tapatalk

I think I would try that, then try reloading the firmware & configuration.  If that does not help, I would be boxing it up and taking to my dealer for repairs.