18-May-2015, 22:01
(18-May-2015, 15:44)Mikeeo Wrote: Any one out there (D400 or D800) please tell me from start to finish how to get my system in 8.0.0 and after that use the new configurator.
What pitfalls should I avoid to make things work?
Is it possible to have RAM, ICM and SAM at the same time an utilize its functions fully? When I configured the last times under 8.0.0 (only had one channel playing) I noticed if choosing RAM I could not adjust SAM % and where do I utilize ICM? Or do I ask to much of this despite that all functions to me is equally important!?
Best/Mike
I only had my left channel playing up to the second attempt to update.
Somehow the power switch of my slave unit was flakey, and pressing it for 5 seconds did not do the trick.
I ended up disconnecting the power cord for 10 seconds, and connecting it again, which triggered the successful update of the firmware.
Then things worked fine.
I like 8.0!
D400; Stereolab Tombo Tron coaxial for master -> slave; Kubala-Sosna Elation interconnects, power, and speaker cables; Spendor D7 speakers; Bryston BDP-2 w. latest sound card & upgraded fuses; Bybee Stealth Power Purifier conditioner connected with IsoTek EVO3 Syncro SE to wall socket