19-May-2015, 09:31
(18-May-2015, 22:32)Ron D Wrote: So installed V8 into my 200 and all was OK, at least for my use which is strictly Line in & digtial in (spdif). Don't use wif, ethernet, etc.
Was playing fine, appeared to run cooler and no sound when volume turned up loud (no source engaged) at the speaker drivers so I thought perfect!
Couldn't leave well enough alone and decided to try to turn off dynamic power function (has always been on in the past) . Downloaded the new config file and now the unit won't stay turned on - hit the power button and cycles through a few screens - never reaches the volume screen and dies leaving the unpowered 200 screen in the display. Maybe revert to 7.1.1 until all the bugs are taken care is the answer.
Could kick myself....
Have you tried the usual suspects - hard reset (unplug mains power,after first turning off or unplugging at the power outlet); hard reset without any input cables attached (apparently this is how to jolt the amp out of protection mode), and also without the SD card, this should power up in factory config?