23-May-2015, 22:59
(23-May-2015, 21:28)Antoine Wrote:(23-May-2015, 20:26)Triggrhappy01 Wrote: I took some REW measurements of 7.1.1, 7.1.3b and 8.0.0. With SAM defeated, and ICM defeated in 8.0.0, there is no significant difference between the three. Any variation can be attributed to measurement error.
However, in 8.0.0, ICM (Intelligent Cinema Mode) is defaulted to ON and you are most likely hearing its effects as shown below when you load 8.0.0 and a config file created under the "new" Configurator.
As far as I can tell, there is no way to defeat ICM from the configurator - meaning the only way to turn it off is to map the "ICM on/off" function to a remote button and then manually defeat it. It seems to be a smooth, subtle downward tilt toward the high frequencies, approx. 1dB down at 1 KHz, 2dB down at 10 KHz, and 3dB down at 20 KHz according to the graphs. The hinge point appears to be around 100-150 Hz. Note that ICM seems to adjusted dynamically depending on volume, and this represents only a single volume setting.
(Expert 200 was at level of -18 for all measurements. KEF LS50s are on loan and it's unknown if they are fully broken in. UMIK and latest REW version for OS X. Except for the "ICM on/off" remote control mapping, the same config file was used for all FW versions - downloaded 5/17 using the new Configurator. The overall measurement level is low but all measurements were made under the same conditions. FW version measurements taken approx. 30min apart. DPM was on during all 8.0.0 measurements. Room is 12x20 and reflective. Speakers are along the long wall, microphone approx. 8ft from each speaker.)
Wow, this is brilliant, thank you!!!
If I understand you correctly ICM is always on with FW 8.0 unless you manually defeat it. If correct then Devialet has screwed up big time...again...
Indeed there's no way to disable it in the configurator, nor is the setting currently stored in the config file. It's like the 'polarity invert' setting which also can't be found there but is only a running parameter with a certain default. So we're indeed forced to assign a button for it to disable it manually.
This place is getting more like Salem every day !!!!!
UK kit - Technics SP10 - Technics EPA-501 - AT33SA - NUC5i3 - W10 - Roonserver - Roon AIR - Devialet 1000 Pro CI - Blue Jeans Speaker Cable (0.5 metre each side) - Magico S5
Spain kit - NUC7i5 - W10 - Roonserver - Roon AIR - Devialet D250 Pro CI - Blue Jeans Speaker Cable - Ergo IX speakers
Spain kit - NUC7i5 - W10 - Roonserver - Roon AIR - Devialet D250 Pro CI - Blue Jeans Speaker Cable - Ergo IX speakers