Adding second d200

[thumb5]

Thanks I will retread and set up as instructed.  Digital coax to link d200's, leave the innards alone, perhaps configurator will help me be sure which speaker outputs to use.  I assume one right amp one left with corresponding speaker outputs.

Again thanks.

Unless I've misread/misunderstood, you might be on the wrong track with your speaker connections.  You should configure both amps to be in mono mode, then connect the speakers between the two red terminals on each amp.  That is, for the amp that's configured as the left channel (usually the master, IIRC) your left speaker should be connected between the two red terminals on that amp.  Likewise for your right speaker on the other amp.  This is shown by the configurator when you switch to dual-mono.  It looks odd at first but you'll get used to it...