Connecting SUB - High/Low Pass Filters not working.

[strummer]

Hmm, seems a bit odd.  Are you sure it's reading your configuration properly?

By the way, not wanting to be funny, but how sure are you that the output is not being filtered?  How about setting up a high-pass filter on the mains with pre-out enabled, full-range with pre-out disabled, temporarily disconnect your sub, and then switch between sub-on and sub-off: you should be able to hear the filters cutting in and out.  If you want to make it more obvious, try raising the corner frequency and/or increasing the slope, just for testing.

Thanks again Ian

Output is definitely not being filtered, because I'm using a Tone Burst CD (plays tone bursts at each frequency). Both main speakers & SUB are receiving the full range.

I've re-configured 5 times & each time the same result.

I just read that old thread & will read it over until I take it all in.

One comment about being able to set something for each input in General Settings interests me. I'll investigate that.



Thanks