08-Aug-2016, 06:01
(08-Aug-2016, 04:37)Pim van Vliet Wrote:(08-Aug-2016, 04:16)Duomike Wrote:(22-Jul-2016, 18:02)GuillaumeB Wrote: FIRMWARE V10.0.2
- Support of the new Expert Pro line
- New graphical chart
- Original d’Atelier reaches 1000 Watts of power
Guillaume
Tried upgrading to the new firmware. Got following error message:
SW. FF. FF
H.W 5.0.0
SD card error B 351
DSPD 0210.HEX
Does anyone got a clue what went wrong? Acc. to instruction from dev help site the sd card must be empty before copying the 17 files. Initially i left the configuration on the disk because a friend did so without problems.
Deleted the conf. file but problem still unchanged.
If I delete the 17 files will my dev automatically go back to the previous FW?
This is what I do every time I make any change (firmware or configuration)
I delete the files from my SD card. Then take my SD card out and re-insert it. I then check whether it is empty or not. Only once I've confirmed it's empty I copy the new files over.
It might just take a minute longer and it shouldn't need to be done but in the end I know it always works so it saves time re-doing things.
Good luck!
Pim
Thanks Pim,
deleted all the files on the card and downloaded the FW again and re copied it onto the card. FW installed successfully.
After that I again deleted all files and downloaded the conf. file again. Everything good now!
Highly modded avantgarde omega duos, slightly modded d200, d-sonics m3 800 s class d amp to drive the subs of my duos, all equipment on silent running audio platforms.
DCS Network bridge connected with AQ diamond to Router and with special Belden 1694a digital cable (cable is cryoed, mechanical damped and using very high quality solder to KLEI Harmony Bullet plug)
S/C is Shunyata biwire Delta, 2 Delta p/c on the bridge and bass amp, Synergestic dev p/c on the 200, all connected to Shunyata Denali power conditioner
DCS Network bridge connected with AQ diamond to Router and with special Belden 1694a digital cable (cable is cryoed, mechanical damped and using very high quality solder to KLEI Harmony Bullet plug)
S/C is Shunyata biwire Delta, 2 Delta p/c on the bridge and bass amp, Synergestic dev p/c on the 200, all connected to Shunyata Denali power conditioner
