Firmware 7.1.3 vs 8.1.3 vs 10.0.2

[no32]

Hold down the tone button on the remote for a couple of seconds, then press the source button a couple of times until you get to the screen which says "Last Fault", there you will see, yes, you've guessed it: the last fault detected. If you have a fault, raise a ticket with Devialet and please post the error code. You don't say what model you have.  Obviously, if you have a dual mono version (200, 220,400,440 etc.) don't forget to look at the data from both of the amps.

I was thinking that it might be useful for members if we had some sort of data base for error codes, although these sort of errors don't crop up in many posts. What do you think?

I searched for error and last fault is empty

I'm using 2 x 250 as 800
After resetting both amps I listen for about 4 hours without any issues at all.

I'm glad no faults showed and you haven't had any further problems. Perhaps it was one of those one-time-only-glitches.

I hope so. So far no problems at all . Today I listen to music over 2 hours without any issues at all