Integrating 440 with Cinema

[Confused]

OK Guys, very useful...

However, not being a 'whizz' at this stuff I have a few more question on this, if you don't mind?

You mention making changes on the Dev side, and in the configurator I see under the line-in settings RMS (set at 2 at the mo), and another slider for pass through gain (I suppose) set at -15db. Are any of these the ones - the latter seems reasonable?

cheers

Keith

Pass-through set to -15dB would tend to make your front speakers relatively quiet.  This is of course exactly what you stated the issue was in your first post, so I think this looks like the issue.  If you try this at 0dB you should get the volume level roughly right, and then fine tune on the Anthem.