AQVox AQ-SWITCH-8

[Celts88]

Confused

I posted on CA after you asking how to ground the switch.

Sorry for this is dumb question, but realise one end of the ground cable goes to the AQVOX, but where does the other end go?

I was thinking of getting a normal 3 pin UK plug with one wire connected to earth (ground), and connecting this to the Aqvox. (This should work fine with Australian spec plugs also)  The alternative is to connect to the little earthing post at the back of the Devialet.  Personally, I find the Devialet's earthing post a little fiddly and difficult to get right, this is based on use for my turntable ground.

Confused

Sorry if I come across like your username, so if I take a simple extension lead, remove the Neutral and Live cables from the plug that goes into my expansion filter board, and then take the earth cable and attach this to the AQVOX I'm good to go.

Or I can take a single cable connected to the AQVOX and attach this to the Earthing point on my Expert Pro then this will do the same (how is the Expert earthed).

Thanks for your help.