[attachment=2771 Wrote:zdenes pid='74139' dateline='1523378519']You have to make sure in the configurator that the SW output is 'ON' when you start the Devialet. In some firmware versions the default is off. You can also nominate a button on the remote to switch it on and off. Try that and see if you can switch it on and off.
I actually set up mine that when I press the 'off' on the remote, my main speakers go back to full range (and not crossed with a high-pass filter).
In other words, I can A/B test my system with the subs (I have two) on and the main speakers crossed at 80Hz and just the full range speakers without the subs.
It is definitely something in the configurator. Check out the 'pre on' 'pre off' setting and also you can do that setting differently for each input.
Zoltan
Yes, I checked that and when I toggle through the remote I can see the display says "Bass 2.0" and I press again and I get "Bass 2.1" so I think that would indicate Left, Right, and SW. In fact, I also set up a button for "Pre on" "Pre off" so I can control both. I have tried everything I can think of but nothing will let the SW output be active and work.
