04-Feb-2024, 20:38
(This post was last modified: 04-Feb-2024, 20:46 by mmorrison55.)
finally about to receive my second d 200. in preparation, I was looking at the configurator and trying to create a new configuration. i will be using an RCA to AES/EBU for the digital "chain". and I was going to add a trigger cable as I understand one is required if I wish to be able to see both LCD screens simultaneously. also, I assume the top unit in the configurator is the Master and the bottom the slave. my confusion is from the trigger. I don't seem to be able to enable the trigger on the slave. is this correct?
I would have thought the master would be a "trigger Out" and the slave a "trigger in", but maybe I am not understanding the trigger operation in this setup, but you can see the trigger on the slave is not configurable at all. I assume I would still plug my 3.5 mm cable into this bottom trigger port on the slave?
also, re the download. do I need to download a configuration from the master and the slave? or would the master download contain the detail for loading into the slave? I know I have to add a configuration onto both, just not sure if one SD card contains all the needed configuration for both master and slave and how does it know which unit is which?
I would have thought the master would be a "trigger Out" and the slave a "trigger in", but maybe I am not understanding the trigger operation in this setup, but you can see the trigger on the slave is not configurable at all. I assume I would still plug my 3.5 mm cable into this bottom trigger port on the slave?
also, re the download. do I need to download a configuration from the master and the slave? or would the master download contain the detail for loading into the slave? I know I have to add a configuration onto both, just not sure if one SD card contains all the needed configuration for both master and slave and how does it know which unit is which?