PS Audio P3 for D400 + Montis

[philoouu]

Hello I have a PS audio P3 with my D250. It is more than enough for D250/D800. I think it is using only around 1/10 of the capacity for my D250 but I will check this number again. No idea about your other devices.


Sent from my iPhone using Tapatalk

thanks for chiming in. ideally it should serve the following components:

D400
Montis (with built in 200W amp per speaker)
Aurender X100L
Denon DCD1520
Denon DNP720
Linksys network bridge/extender

Hello

Please have a look at Antoine's comment 

http://www.whatsbestforum.com/showthread...AC/page125

As you can see in normal use it is less than 10% of the capacity with a few devices plugged in.

The good point with the PS3 is that it makes absolutely no noise and compared to PS5/PS10 it is much smaller.
Honestly speaking more than improving the sound it makes your set-up more consistent from one day to the other. Contrary to very subjective improvements due to (expensive or not) cables, this device is objectively changing the current entering your system.


philoouu