Hello,
I am re-posting here a question I asked on another thread. I think it can be pertinent to this topic too.
The question regards the level meters on the Devialet.
I have an Airtight PC3 cartridge with a factory suggested output voltage of 0.55 mV. I did some test changing voltage and I noticed that even if the level meters in the devialet are well underneath the yellor/red area the yellow LED that is on the front of the Devialet started occasionally flashing Red signalling a clipping. My understanding was that if the level meter were in the green range I should be in the safe area.
With the suggested settings the 0.55mV I don’t have any red flashing but obviously I need to push the volume more.
Did anyone noticed a similar behavior or can explain me the logic behind this?
Thanks
Marco
I am re-posting here a question I asked on another thread. I think it can be pertinent to this topic too.
The question regards the level meters on the Devialet.
I have an Airtight PC3 cartridge with a factory suggested output voltage of 0.55 mV. I did some test changing voltage and I noticed that even if the level meters in the devialet are well underneath the yellor/red area the yellow LED that is on the front of the Devialet started occasionally flashing Red signalling a clipping. My understanding was that if the level meter were in the green range I should be in the safe area.
With the suggested settings the 0.55mV I don’t have any red flashing but obviously I need to push the volume more.
Did anyone noticed a similar behavior or can explain me the logic behind this?
Thanks
Marco