Arch - White light flashing

[wbraveheart]

Hi all, 

Hope you are doing well. I have my turntable connected through RCA to Devialet Arch and then to my 2 Phantoms I. 
Yesterday, I had to reset the Arch as it was not working anymore. Since then, I am unable to connect the Arch anymore, I have a flashing white light and even after several restarts, it doesnt work. Time to time, the light is flashing in blue.

Any clues?

Thanks guys.

[dany1337]

Hi all, 

Hope you are doing well. I have my turntable connected through RCA to Devialet Arch and then to my 2 Phantoms I. 
Yesterday, I had to reset the Arch as it was not working anymore. Since then, I am unable to connect the Arch anymore, I have a flashing white light and even after several restarts, it doesnt work. Time to time, the light is flashing in blue.

Any clues?

Thanks guys.

Hi wbraveheart, did you get any workaround for your Arch issue? Actually I am facing the same. My Arch stucked during reboot after I have tried to change of the "Device name" through web browser interface. It don't want to boot up anymore. Moreover Arch is not completing the reset to the factory settings sequence-  it's confirming the reset by the purple light, but after a few seconds it is going back to the white flashing state. Arch is not recognizable by the Devialet App....but during the few minutes after each boot, it is still log in into my local network, getting their old IP ...even joining bonjour   but just in a zombie mode. It is not responding to the REST api queries as well.
Firmware 2.18.3. 

I will be grateful for any hints.