Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
iPad/iPhone remote
#1
I notice that when using the iPad or iPhone remote for the D440 Pro CI, it will now power on the amps from a fully off position. i.e. not in standby mode and with the screens completely blank.
I’m sure that this was not the case before the CI upgrade and is a very handy addition (for me anyway).
It would be even better if you could power the amps completely down using the iPad remote. As it is, you can only put them into standby mode.
Project Eperience X Pack with Ortofon Rondo Red MC, Oppo BDP 105D, 2 x Sonos Connect, QNAP HS251+ NAS with 2 X 6TB Western Digital Red, Mac 5K 32GB running Lifetime Roon, iPad Pro 12.9" for remote control.  Etalon Ethernet Isolator, Devialet 440 Pro CI, Sonus faber Olympica ll with Isoacoustics Gaia ll feet, Auralic Taurus Mkll headphone amp.Denon AH-D5000, Sennheiser HD600 and HD800 with Cardas cable,  Van Den Hul The First Ultimate and Crystal interconnects, Furutech power cables, GSP Audio Spatia speaker cable.
South Coast England
Reply
#2
That is a nice upgrade, and I agree a two way on/off would be better. It would be best if there were a true off state at all. Unless the Pro CI has changed the Devialet amps still consume significant power doing nothing (as close to off as possible).
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)