Ledesc D200 - Printable Version +- Devialet Chat (https://devialetchat.com) +-- Forum: Devialet Chat (https://devialetchat.com/Forum-Devialet-Chat) +--- Forum: Your Systems (https://devialetchat.com/Forum-Your-Systems) +--- Thread: Ledesc D200 (/Thread-Ledesc-D200) Pages:
1
2
|
Ledesc D200 - ledesc - 22-May-2015 Hi guys. Here am I, with brand new D200 and B&W 805 D !!!!! Just updated with 7.1.3 (the factory firmware was 7.1.2) and made a quick config. I just begin with some difficulties, first the IOS remote on my iPhone just shows informations, but I can't interact, if I perform an actions notion happens, but if I use the real remote I can see the new information on the iPhone..... Second, I just installed AIR on my windows PC, but I can't enable AIR streaming, I just see Disable Devialet AIR that is ticked on the icon in the task bar... So I begin this journey with CDs !!!!!! Advices will be appreciated Edit (May 2016): pictures in my new apartment RE: Ledesc D200 - Confused - 22-May-2015 Another sighting of the illusive 7.1.2 ..... Ledesc D200 - ledesc - 22-May-2015 I do not understand.... The wifi is set up, on the dev screen it's ok, ip showed... But I can't ping it.... Is the wifi faulty ? When wifi only, on the remote app of the iPhone I see Wifi, but can't control anything, when I plug my Ethernet cable, then it show eth on the remote and I can control.... RE: Ledesc D200 - thumb5 - 22-May-2015 (22-May-2015, 18:59)ledesc Wrote: I do not understand.... Sounds unlikely that the wi-fi is faulty if it's connected to the AP and been assigned an IP address (I assume you're using DHCP). Firewall problem? Are you pinging it from a PC or Mac? Oh, I see you mentioned "task bar" above so I guess a PC. Might be worth trying with the firewall disabled, temporarily. Ledesc D200 - ledesc - 22-May-2015 Yes I both tried DHCP and fixed IP. You can ping the wifi IP ? I have no firewall, everything (iPhone, iPad, PC...) can connect to the internet box in wifi. RE: Ledesc D200 - thumb5 - 22-May-2015 Yes, the wi-fi interface should respond to ping. (At least, it does with 7.1 firmware; I haven't tried 8.0.) I meant the Windows firewall, by the way. Have you tried a wired connection? RE: Ledesc D200 - moreno1973 - 22-May-2015 (22-May-2015, 17:44)ledesc Wrote: Hi guys. Hello Listen Your system with SAM on!!! 805D sounds much better with SAM... Ledesc D200 - ledesc - 22-May-2015 Yes SAM on I put another config (DPM off) and know the app remote works.... Will check tomorrow as my wife just arrived from work. Let's demo with her favorite CDs !!!!!! RE: Ledesc D200 - Pecarosh - 22-May-2015 (22-May-2015, 17:44)ledesc Wrote: I just begin with some difficulties, first the IOS remote on my iPhone just shows informations, but I can't interact, if I perform an actions notion happens, but if I use the real remote I can see the new information on the iPhone..... Did you under configurator, remote settings "Authorised" app remote control? If not, enable it and load new configuration into devialet. RE: Ledesc D200 - thumb5 - 22-May-2015 Great stuff! Maybe DPM turns off the network interfaces when the unit is in standby - if so, thanks for finding out! Anyway, enjoy your listening! |