29-Dec-2021, 20:13
Hi
The issue I had with the common parameters settings caused music to suddenly stop playing after about 1 minute 20 seconds. Sometimes it was every track some times it would play fine for a full track then stop playing on the second track. The counter would carry on but no sound. I had to skip back or forwards to get sound again
If this is what you are also experiencing then I suggest you change the streaming options HTTP mode from chunked to no length. Do this in your phantom room set of parameters not in the common parameters settings.
This should resolve the issue you mention. I have also changed audio format to UPnP player to pcm or Flac but they didn’t seem to make any difference for my issue.
I tried to change the max sample rate from 48000 to higher values but it didn’t affect my setup presumably because I don’t have any hires music and also probably because the phantoms down sample to 48Khz anyway.
I hope this gives you some ideas. As I said earlier you can change values in the parameters for your “room” but change them back to the defaults if things get worse or are no better. There may have been other settings I tried but have forgot what I did. Now it is working perfectly for my setup, I only have the HTTP mode different to any common parameters.
Sent from my iPhone using Tapatalk
The issue I had with the common parameters settings caused music to suddenly stop playing after about 1 minute 20 seconds. Sometimes it was every track some times it would play fine for a full track then stop playing on the second track. The counter would carry on but no sound. I had to skip back or forwards to get sound again
If this is what you are also experiencing then I suggest you change the streaming options HTTP mode from chunked to no length. Do this in your phantom room set of parameters not in the common parameters settings.
This should resolve the issue you mention. I have also changed audio format to UPnP player to pcm or Flac but they didn’t seem to make any difference for my issue.
I tried to change the max sample rate from 48000 to higher values but it didn’t affect my setup presumably because I don’t have any hires music and also probably because the phantoms down sample to 48Khz anyway.
I hope this gives you some ideas. As I said earlier you can change values in the parameters for your “room” but change them back to the defaults if things get worse or are no better. There may have been other settings I tried but have forgot what I did. Now it is working perfectly for my setup, I only have the HTTP mode different to any common parameters.
Sent from my iPhone using Tapatalk
