(02-Aug-2025, 19:05)parkerswede Wrote: Yes, I have the correct connections for the cables. Only red connectors. Red connector is closest to the XLR, black is farther away. I did have a lot of trouble with the remote control not switching sources. Finally erased everything off the Master SD card and downloaded a new file. Fixed the problem. Can you feed the raw speaker cable end through the bottom of the connector in the back and just tighten it up? Right now, I am using a clamp-on end with an RCA connector.
You probably know this already but: Please be careful if you are using bare wires. Make sure that they can’t short out anywhere; no stray strands etc. I used to clamp the wire down then trim the wire back to the post. Hope you are now noticing a bigger difference between 220 vs 440.
Oppo BDP-105 - Roon lifetime - Dutch & Dutch 8c
South Coast England
