Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IEC contacts fits badly in my 400 amps.
#6
Hmm, that's odd. I've used about 3 or so of these plugs and they've been pretty good for me. Wondering if the contacts are bent a bit inside?
The only drawback I've had with them is the plastic sleeve part doesn't allow for a very thick mains cable but is always just a tiny bit too tight for the cable I use. I absolutely can't use the plug without all its parts though so I end up filing the inside of the sleeve with a round file for about half an hour until it fits. Sad, I know.
Reply


Messages In This Thread
RE: IEC contacts fits badly in my 400 amps. - by Rufus McDufus - 23-Jul-2015, 13:23

Forum Jump:


Users browsing this thread: 1 Guest(s)