24-Jul-2015, 05:24
Tightening the internal contacts is a very good suggestion.
I tried this when I built my first Supra LoRad PC, but without a tight connection between the FIEC body and the MIEC,
I still got cable droop.
Adding the heat shrink solved the problem and I haven't had any problems for the last ten years.
IMO, unless you're using a PC FIEC and MIEC/PEM made by the same manufacturer, you have the potential for a loose/sloppy fit.
I'm sure Devialet's take on all of this, would be that the fit of the stock PCs into the PEMs is perfectly tight.
I tried this when I built my first Supra LoRad PC, but without a tight connection between the FIEC body and the MIEC,
I still got cable droop.
Adding the heat shrink solved the problem and I haven't had any problems for the last ten years.
IMO, unless you're using a PC FIEC and MIEC/PEM made by the same manufacturer, you have the potential for a loose/sloppy fit.
I'm sure Devialet's take on all of this, would be that the fit of the stock PCs into the PEMs is perfectly tight.
