Mine was easier to remove due to PCB being removed and disassembled but still a struggle. Best way would be to bend a pair of long cheap hemostat jaws inward towards each other about an inch in from the tips after heating cherry red so they don't break/snap. However F'tech just notified me today that their newest PEM is integrated into the IEC plug ala two-birds-with-one-stone. I didn't want the PEM at any cost so I eliminated it.
Here's the link: http://www.furutech.com/2015/08/18/11637/
BTW channel locks won't come close to fitting the narrow confines on the inboard side of the OEM PEM retaining clips.
Here's the link: http://www.furutech.com/2015/08/18/11637/
BTW channel locks won't come close to fitting the narrow confines on the inboard side of the OEM PEM retaining clips.
Statements in my posts are opinion only, not to be construed as fact. Any projects I engage in are at my own risk! Their outcome cannot be assured and may result in success, small/no change or catastrophic failure. I encourage no one rely on anything I say or do as gospel and to realize your mileage may vary!
