Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What's wrong with this remote?
#12
I can't believe some people still think the remote uses Bluetooth after it has been said a gazillion times that it uses RF and works with early Phantoms that have no Bluetooth!

Anyway, there is most certainly a sleep mode that the remote goes into and it takes about half a second to wake up the first time you use it after a while. The movement does catch-up though. So if you turn it quarter of a turn in 0.5 a second, you will end up with that volume change but just a little later in time than you might have expected. However, the impact of this is minimal and you would not be able to turn the volume so much as to end up with full volume shock moments.

I suspect in the case of the original poster, that something isn't right here and this is not the normal sleep/wake-up delay. Tracking it down is a bit of a nightmare though. It could be that remote is slow to wake-up. It could be the phantom isn't listening to the RF when it should be. It could be interference, although we have no idea what frequency the remote uses I believe.

However, if I experienced this the first thing I would try would be a complete and total reset of everything and start fresh just in case.
Reply


Messages In This Thread
What's wrong with this remote? - by sekriT - 18-Apr-2016, 01:43
RE: What's wrong with this remote? - by steenh - 18-Apr-2016, 01:52
RE: What's wrong with this remote? - by steenh - 20-Apr-2016, 06:36
RE: What's wrong with this remote? - by sekriT - 21-Apr-2016, 00:33
RE: What's wrong with this remote? - by sekriT - 21-Apr-2016, 01:38
RE: What's wrong with this remote? - by jonstatt - 25-Apr-2016, 08:21
RE: What's wrong with this remote? - by sekriT - 06-May-2016, 00:37
What's wrong with this remote? - by Phs - 06-May-2016, 13:09

Forum Jump:


Users browsing this thread: 1 Guest(s)